LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (53 - Body Rear - CARRERA (997)) >> WM 536855 Replacing Rear Wheel Housing (All Models) >> Installing Rear Wheel Housing >> Installing Inner Rear Wheel Housing

Installing Inner Rear Wheel Housing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fitting inner rear wheel housing to the body
    1. 1.1. Place the inner rear wheel housing against the body and secure to the straightening set.
    2. 1.2. Fix the inner rear wheel housing in place with tensioning clamps.
  2. Welding in inner rear wheel housing
    1. 2.1. Resistance spot-weld the inner rear wheel housing in areas -A, B, C, D, E-  .
      Fig 1: Identifying Welding In Inner Rear Wheel Housing
      G09823604Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Welding in inner rear wheel housing
    1. 3.1. Plug-weld the inner rear wheel housing in areas -A, B, C-  using inert gas.
      Fig 2: Identifying Welding In Inner Rear Wheel Housing
      G09823605Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  4. Welding in inner rear wheel housing
    1. 4.1. Plug-weld the inner rear wheel housing in areas -A, B, C-  using inert gas.
      Fig 3: Identifying Welding In Inner Rear Wheel Housing
      G09823606Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  5. Welding in inner rear wheel housing
    1. 5.1. Apply a full weld to the inner rear wheel housing in areas -A-  and -B-  using inert gas.
      Fig 4: Identifying Welding In Inner Rear Wheel Housing
      G09823607Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  6. Welding in inner rear wheel housing
    1. 6.1. Apply a full weld to the inner rear wheel housing in area -A-  using inert gas.
      Fig 5: Identifying Welding In Inner Rear Wheel Housing
      G09823608Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  7. Install side reinforcement (frame for light). → 531755 SIDE REINFORCEMENT  - section on "Installing"
  8. Installing inner side section
    1. 8.1. Only on the Coupe
      1. 8.1.1. Install inner side section (lower part). → 536155 REPLACING INNER SIDE SECTION  - section on "Removing"
    2. 8.2. Only on the Cabriolet
      1. 8.2.1. Install inner side section. → 536155 REPLACING INNER SIDE SECTION  - section on "Installing"
scientia non olet · About LEMON Manuals