LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (53 - Body Rear - CARRERA (997)) >> WM 536155 Replacing Inner Side Section (Except CABRIO Models) >> Preparing Connection Areas Of The Body For Installing The Inner Side Sections >> Preparing Connection Areas Of The Body For Installing Inner Side Sections (Lower Parts)

Preparing Connection Areas Of The Body For Installing Inner Side Sections (Lower Parts)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean undersealing, adhesive residue and paint off the body connecting flanges in the marked areas -A, B, C-  using a hot-air gun or rotary brush. Grind the connecting flanges until bare.
    Fig 1: Cleaning Welding Areas
    G09823475Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Coating spot-weld flange areas with zinc powder paint
    1. 2.1. Coat all spot-weld flange areas with zinc powder paint.


  1. Clean undersealing, adhesive residue and paint off the body connecting flanges in the marked areas -A, B, C-  using a hot-air gun or rotary brush. Grind the connecting flanges until bare.
    Fig 1: Cleaning Welding Areas
    G09823523Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Coating spot-weld flange areas with zinc powder paint
    1. 2.1. Coat all spot-weld flange areas with zinc powder paint.
scientia non olet · About LEMON Manuals