LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (53 - Body Rear - CARRERA (997)) >> WM 535555 Replacing Side Section (Except CABRIO Models) >> Preliminary Work For Body Repairs With Straightening Bench

Preliminary Work For Body Repairs With Straightening Bench

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove add-on parts in the repair area
    1. 1.1. Remove add-on parts in the repair area according to the extent of damage to the vehicle.
  2. Equip straightening bench with straightening attachments
    1. 2.1. Equip straightening bench with the basic straightening attachments according to the plans included with the straightening attachments.
  3. Place vehicle on the straightening bench
    1. 3.1. Position vehicle on straightening bench, align according to the reference holes and bolt firmly to the straightening attachments.
  4. Cover add-on parts adjacent to the vehicle repair area
    1. 4.1. Cover all add-on parts remaining on the vehicle and the adjacent areas with fire-proof protective covers.
  5. Reshape connection area of the sheetmetal parts to be replaced
  6. Expose welding areas
    1. 6.1. Remove undersealing, paint, etc. from the welding areas of the body with a hot-air gun or rotary brush.
scientia non olet · About LEMON Manuals