LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (20 - Fuel Supply, Control -- CARRERA (997)) >> WM 206619 Removing And Installing Fuel Pump (Except Turbo Coupe, Turbo S Coupe, Turbo CABRIO & Turbo S CABRIO) >> Preliminary Work >> Preliminary Work - Carrera 4

Preliminary Work - Carrera 4

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place protective covers on the vehicle.
  2. Disconnect the battery.

    → 2706IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY

  3. Remove luggage compartment cover.

    → 700519 REMOVING AND INSTALLING FRONT LUGGAGE COMPARTMENT TRIM PANEL - section on "Removing"

  4. Remove cover for tank flange.

    Unscrew four M6 cap nuts -2-  , remove the four washers and lift off the cover. Check seal for signs of damage.

    Fig 1: Identifying Cover For Tank Flange
    G09828262Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  5. Remove fuel level sensor.

    → 201519 REMOVING AND INSTALLING FUEL LEVEL SENSOR  - section on "Removing"

  6. Drain the fuel tank until the fuel level is lower than the pump.

    → 2010EN DRAINING AND FILLING THE FUEL TANK  - section on "Draining"