Installing lower part of rear apron

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

If the lower part of the rear apron -1- or the rear apron -2- is replaced, a hole must be drilled in the marked area of the rear apron (crosshairs) using a 4 mm drill bit.

Fig 1: Identifying Hole In Rear Apron

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Press lower part of rear apron -1- into the rear apron -2- (-arrow A- ) until the locking lugs engage securely -arrow B- .

Fig 2: Installing Lower Part Of Rear Apron
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw down fastening screw -3- at the left and right between the lower part of the rear apron -1- and the rear apron -2- .