LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (63 - Bumpers -- CARRERA (997)) >> WM 635519 Removing And Installing Rear Apron (Turbo Coupe, Turbo S Coupe, Turbo CABRIO, Turbo S CABRIO, Gt2, Gt2 RS) >> Installing rear apron >> Removing and installing holder for rear apron

Removing and installing holder for rear apron

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove holder for rear apron.
    Fig 1: Removing Holder For Rear Apron
    G09824777Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    1. 1.1. Unscrew fastening screws -2-  and remove holder -1-  (-arrow-  ).
  2. Install holder for rear apron.
    Fig 2: Installing Holder For Rear Apron
    G09824778Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    1. 2.1. Position holder -1-  on the body -arrow-  so that it is flush with the side panel.
    2. 2.2. Tighten fastening screws -2-  . → Tightening torque: 10 Nm (7.5 ftlb.) 
scientia non olet · About LEMON Manuals