Adjustment dimensions of the bumper
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Information
- To reduce adjustment work to a minimum when fitting the rear apron, the rear bumper and rear retaining strip must be aligned with the lower edge of the rear lid according to the dimensions shown.
- However, the precondition for precise positioning of the components is that the rear lid is optimally adjusted and correctly locked in the lock in accordance with the joining plan, before the rear bumper and rear retaining strip are fitted.
Information
All measurements refer to the position V = 280 mm .
- Adjust the rear lid according to the joining plan. → 5 Diagram - body gap dimensions
- Adjust both sides of rear bumper -2, 2A- to dimension -Y- → Adjustment value: 166 mm . The measurements can be changed by loosening and moving the impact pipes and impact absorbers (Canada version).
- Adjust rear retaining strip -1- according to dimension -X- → Adjustment value: 168 mm .