Troubleshooting The Air Conditioning System Following Complaints About Noises

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

The troubleshooting steps shown must be used if complaints are received about noises in the air-conditioning system.

→ WM 8700IN INSTRUCTIONS FOR REPAIRING AIR-CONDITIONING SYSTEMS AND STORING SPARE PARTS

Information

If it is not possible to clearly detect a leak using a leak detector, then only the leak detector additive supplied by SPEKTRONICS may be used. Leak detector additive: Traserline TP 3860 in dissolved form.

This leak detector additive is available from service equipment providers (e.g. Waeco).

For filling this Traser additive, special adapter kits are required, which are also available from service equipment providers (e.g. Waeco).

Information on how to use the air-conditioning system and the procedure for filling it can be found in the operating instructions for the adapter kits.

Status	Specification OK	Specification not OK
1) Check for noises from around the compressor. Start the engine and switch on air conditioning.	No unusual operating noises can be heard from the air conditioning system. Continue with Step 2) .	Noises coming from the air conditioning system. >> Mechanical noises, continue with Step 3) If you have already carried out Step 3) , continue with Step 5) >> Squeaking noises, continue with Step 4)
2) Start the vehicle and check the air conditioning system for the prescribed nominal temperature values. → WM 8701IN NOMINAL VALUES FOR PRESSURES AND TEMPERATURES	Nominal values OK and no noises from the air conditioning system. Function OK. No further action required.	Nominal values not OK, proceed according to "Troubleshooting the air conditioning system following complaints about cooling output".
3) Check the following points one after the other: Remove drive belt and check condition. Check the bearing clearance of the pulley and magnetic coupling. Check refrigerant level. Drain refrigerant and measure the amount of refrigerant. >> Not enough refrigerant. → Draining And Filling In Refrigerant		Replace drive belt if necessary. Replace pulley/magnetic coupling if necessary. → WM 872719 REMOVING AND INSTALLING MAGNETIC CLUTCH Fill the air conditioning system with the prescribed amount of refrigerant. → WM 8700IN TECHNICAL DATA, AIR-CONDITIONING SYSTEM . Check refrigerant circuit and connection points using a leak detector. >> Once you have determined the cause of refrigerant loss, replace seal or spare part. Continue with Step 1)
4) Remove drive belt and check for signs of wear or damage.	Systematically broaden the check to determine if there are noises coming from other components.	Replace drive belt if necessary. Continue with Step 1)
5) Replace air conditioning compressor. → WM 873419 REMOVING AND INSTALLING AIR-CONDITIONING COMPRESSOR	Function OK. No further action required.