LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (48 - Steering -- CARRERA (997)) >> WM 489719 Removing And Installing Reservoir For Hydraulic Pump (Except Turbo Coupe, Turbo S Coupe, Turbo S Coupe "Ed. 918 SPYDER", Turbo CABRIO, Turbo S CABRIO, Turbo S CABRIO "Ed. 918 SPYDER", Gt3, Gt2, Gt3 RS, Gt2 RS, Gt3 RS 4.0) >> Preliminary Work

Preliminary Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Vehicle raised incorrectly
  • Danger of fatal injury and material damage should the vehicle fall down

→ Jack the vehicle at the prescribed jacking points.

  1. Raise the vehicle.

    → WM 4X00IN LIFTING THE VEHICLE (ALL MODELS)

  2. Open the engine compartment lid.
  3. Disconnect the battery. → 2706IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY

    Information 

    • The reservoir can only be removed and installed when the power-steering pump is removed.
  4. Remove hydraulic pump.

    →489819 REMOVING AND INSTALLING HYDRAULIC PUMP  .

Includes: