Technical Values
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Hexagon-head bolt (cross member to front body) M12 x 1.5 x 30 | Tightening torque | 100 Nm (74 ftlb.) | |||
| Hexagon-head bolt (cross member to front body) M14 x 1.5 x 120 | Tightening torque | 160 Nm (118 ftlb.) | |||
| Hexagon-head bolt (cross member to rear body) M14 x 1.5 x 50 | Tightening torque | 160 Nm (118 ftlb.) | |||
| Plastic holder for coolant pipe (M6 hexagon-head bolt) | Tightening torque | 10 Nm (7.5 ftlb.) | |||
| Support for coolant pipe (M6 hexagon-head bolt) | Tightening torque | 10 Nm (7.5 ftlb.) | |||
| Support for coolant pipe (center of cross member) | is positioned on the cross member | positioned | |||
| Steering gear to front-axle cross member, M10 x 1.5 x 45 | Tightening torque | 70 Nm (52 ftlb.) | |||
| Universal joint (steering shaft) to steering gear, M8 x 35 | Tightening torque | 23 Nm (17 ftlb.) | |||
| Tie-rod end to wheel carrier (lever), M12 x 1.5 | Tightening torque | 75 Nm (56 ftlb.) | |||
| Stud on front-axle cross member | Tightening torque | 20 Nm (15 ftlb.) | |||
| Fastening nut on stud | Tightening torque | 65 Nm (48 ftlb.) | |||
| Longitudinal restraining straps for fuel tank cover | Observe installation position (marking L = left and R = right) | Tightening torque | 23 Nm (17 ftlb.) | ||
| Diagonal braces to front-axle cross member, M12 x 1.5 | Hexagon nuts | Tightening torque | 100 Nm (74 ftlb.) | ||
| Diagonal braces/crash stop to front-axle cross member, M12 x 1.5 | Hexagon-head bolts | Tightening torque | 100 Nm (74 ftlb.) | ||
| Crash stop to body, M12 x 1.5 | Hexagon-head bolts | Tightening torque | 100 Nm (74 ftlb.) |