Engine Cooling
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Grease O-rings, hoses and lines in the cooling system with Kluberplus Gel (Part No. 000.043.205.93).
| Designation | Thread | Method | Value | Applies to engine | Note | |
|---|---|---|---|---|---|---|
| M97/77 and M97/74 - 997 GT3 | M97/77R - 997 GT3 RS | |||||
| Cover for thermostat | M6 - 10.9 | Torque | 10 Nm (7.5 ft. lb.) | X | X | |
| Water pump bracket with engine carrier to crankcase | M10 - 10.9 | Torque | 65 Nm (48 ft. lb.) | X | X | |
| Inlet and outlet pipes to cylinder housing | M6 - 10.9 | Torque | 10 Nm (7.5 ft. lb.) | X | X | |
| Coolant drain plug to intake socket | M10 x 1 | Torque | 10 Nm (7.5 ft. lb.) | X | X | Replace sealing ring |