LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 122 (39 - Final Drive - Differential, Differential Lock -- CARRERA (997)) >> WM 396219 Removing And Installing Support For Front Final Drive (CARR. 4 Coupe, Turbo Coupe, CARR. 4S Coupe, TARGA 4, TARGA 4S, CARR. 4 CABRIO, CARR. 4S CABRIO & Turbo CABRIO) >> Installing Support For Front Final Drive

Installing Support For Front Final Drive

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fit support with angled side facing upwards.
  2. Screw in and tighten fastening screws.
    Fig 1: Locating Front Final Drive Support Screws
    G09825349Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    Location Description Type Basic value Tolerance 1 Tolerance 2
    Fastening screws securing support to transmission Stage 1 Tightening torque 5 Nm (3.5 ft. lb.)    
  3. Tighten fastening screws again.
    Location Description Type Basic value Tolerance 1 Tolerance 2
    Fastening screws securing support to transmission Stage 2 Tightening torque 65 Nm (48 ft. lb.)    
scientia non olet · About LEMON Manuals