Installing Cover For Final Drive

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Sealing ring must always be replaced.
1. 1.1. Fit sealing ring on cover without twisting it.
2. 1.2. Coat sealing ring with Vaseline.
Install cover for final drive.
1. 2.1. Fit cover for final drive on the transmission and position it using a centering pin 9321 .
2. 2.2. Screw in screws between the cover and transmission.
  → Tightening torque: 25 Nm (19 ft. lb.)
  
  Fig 1: Identifying Final Drive Cover Screws
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Install halfshaft flange.

Fig 2: Replacing Halfshaft Flange Circlip
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 3.1. Replace circlip -A- for the halfshaft flange. To do this, clamp the flange in the vice with a hexagon-head bolt -B- and press the circlip out with the new circlip -A- .
2. 3.2. Grease circlip -A- for easier fitting.
3. 3.3. Drive halfshaft flange -arrow- into transmission using a rubber hammer.
  
  Fig 3: Tapping In Halfshaft Flange
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.