LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 122 (39 - Final Drive - Differential, Differential Lock -- CARRERA (997)) >> WM 394019 Removing And Installing Differential With Differential Lock (Gt2, Gt2 RS, Gt3 & Gt3 RS) >> Installing Differential With Differential Lock

Installing Differential With Differential Lock

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install outer bearing ring.

    If the taper roller bearings with outer bearing shells need to be replaced, measure the differential (total disc thickness S1 and S2) and if necessary adjust. See:

    → 390815 ADJUSTING DRIVE SET - SECTION ON "ADJUSTING" 

    Replacing taper roller bearings, see:

    → 394037 DISASSEMBLING AND ASSEMBLING DIFFERENTIAL - SECTION ON "INSTALLING" 

    1. 1.1. Install left outer bearing ring (large).

      Heat cover to approx. → temperature: 120°C  . After heat exchange, insert left outer bearing ring (large) and drive in using the mandrel from special tool pull-in tool and extractor P254  and a suitable pressure piece Pressure Pieces (4) 9247  .

    2. 1.2. Install right outer bearing ring (small).

      Drive in outer bearing ring with Pressure Piece 3062  and Drive-In Mandrel VW 295  as far as it will go.

  2. Install differential with differential lock
  3. Install cover for differential with differential lock.

    Oil new O-Ring slightly.

    Tighten screws for differential cover -1-  .

    → Tightening torque: 25 Nm (19 ft. lb.) 

    Fig 1: Identifying Differential Cover Mounting Screws
    G09825315Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  4. Replace sealing ring for halfshaft flange.

    → WM 392219 REMOVING AND INSTALLING SEALING RING FOR RIGHT HALFSHAFT FLANGE (TURBO COUPE, TURBO S COUPE, TURBO CABRIO, TURBO S CABRIO, GT2, GT3, GT2 RS & GT3 RS)  - section on "Installing"

    → WM 392219 REMOVING AND INSTALLING SEALING RING FOR LEFT HALFSHAFT FLANGE (TURBO COUPE, TURBO CABRIO, GT2, GT3, & GT3 RS)  - section on "Installing"

  5. Install left and right halfshaft flange.

    → 392519 REMOVING AND INSTALLING RIGHT HALFSHAFT FLANGE  - section on "Installing"

    → 392519 REMOVING AND INSTALLING LEFT HALFSHAFT FLANGE  - section on "Installing"

    Fig 2: Identifying Left Halfshaft Flange Screw
    G09825316Courtesy of PORSCHE CARS NORTH AMERICA, INC.