Installing Long Halfshaft Flange

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Check halfshaft flange for burrs and sharp edges on the transmission end of the shaft and deburr if necessary.

Fig 1: Identifying Halfshaft Flange
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

To avoid damaging the sealing ring in the transmission, the halfshaft flange must be guided carefully into position by hand.
Carefully insert halfshaft flange into the transmission.

Screw in and tighten fastening screws for the mounting saddle using Socket Wrench 9330 .

Fig 2: Locating Mounting Saddle Screws

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Location	Description	Type	Basic value	Tolerance 1	Tolerance 2
Mounting saddle		Tightening torque	23 Nm (ft. lb.) (17)

Screw in and tighten fastening screw for the coolant hose holder on the mounting saddle.

Fig 3: Locating Coolant Hose Holder Screw

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Location	Description	Type	Basic value	Tolerance 1	Tolerance 2
Fastening screw for coolant hose holder		Tightening torque	10 Nm (ft. lb.) (7.5)