Installing Vibration Damper

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

Replace screws for vibration damper.
The screw thread and crankshaft flange thread must not be greased.
Clean the thread on the crankshaft flange to remove grease.

Position vibration damper on the crankshaft flange. Check the position of the dowel pin.
Fit six external Torx screws (E12) M8 x 1 x 25 uniformly in diagonally opposite sequence.
Fit drive belt.
→ 137819 REMOVING AND INSTALLING DRIVE BELT - TURBO .
1. 3.1. Check that the drive belt is seated correctly on the pulleys.
Stake the vibration damper using one of the locating pins 9595/1 -3- .
1. 4.1. Pre-tighten screws uniformly in diagonally opposite sequence according to tightening specifications.
  → Initial tightening: 10 Nm (7.5 ftlb.)
2. 4.2. Final tightening using special tool electronic torque wrench, 2-100 Nm/1.5-74 ftlb.) 9768 .
  → Torque angle: 90°+/-5°
  
  Fig 1: Positioning Vibration Damper
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.