Installing Belt Tensioner

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Install belt tensioner.
Slide belt tensioner -1- onto the tensioning lever. Fit and tighten two M8 screws -2- and one M6 screw -3- .

→ Tightening torque: 23 Nm (17 ftlb.)

→ Tightening torque: 10 Nm (7.5 ftlb.)

Fig 1: Identifying Belt Tensioner
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Install unit carrier.
1. 2.1. Install unit carrier -2- and fit and tighten M10 x 60 screws -1- .
  → Tightening torque: 65 Nm (48 ftlb.)
  
  Fig 2: Identifying Unit Carrier
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. 2.2. Install coolant flange.
  Replace all sealing rings.
  
  Fit coolant flange. Fit and tighten two M6 x 16 screws and one screw on the cable rail.
  
  → Tightening torque: 10 Nm (7.5 ftlb.)
  
  Fig 3: Identifying Unit Carrier Sealing Rings
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.