Removing Drive Plate For Converter

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The toothed segment 9538/1 must be bored to ø 15 mm to guarantee a perfect fit and to avoid damaging the thread in the crankcase.

To counter, fit toothed segment 9538/1 to the crankcase using an M12 x 50 hexagon-head bolt (fine thread).

Fig 1: Toothed Segment 9538/1

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Loosen and unscrew eight M10 x 25 fastening screws on the drive plate. Remove drive plate.

Fig 2: Detaching Drive Plate

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Loosen fastening screw for toothed segment.