LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 119 (13 - Engine - CRANKGEAR, Pistons -- CARRERA (997)) >> WM 136319 Removing And Installing Drive Plate For Converter (CARR. Coupe, CARR. S Coupe, CARR. CABRIO, CARR. S CABRIO, CARR. 4 Coupe, CARR. 4S Coupe, TARGA 4, TARGA 4S, CARR. 4 CABRIO, CARR. 4S CABRIO) >> Installing Drive Plate For Converter

Installing Drive Plate For Converter

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position drive plate on the crankshaft's dowel pin and press on to the crankshaft flange. Insert all M10 x 25 fastening screws (8).
  2. Align toothed segment 9538/1 and tighten fastening screw again.
  3. Screw in and tighten fastening screws in diagonally opposite sequence. Initial tightening: 25 Nm (ftlb.) (19); → Final tightening - torque angle: 120°
  4. Remove toothed segment.
scientia non olet · About LEMON Manuals