Removing Flywheel - PDK Transmission

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Flywheel for PDK -1- with ten fastening screws -2-

Fig 1: Identifying Threaded Joint On Flywheel (PDK)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Position special tool toothed segment 9538/1 -1- for countering at the starter ring gear.
1. 1.1. Place toothed segment on the cast strut.
  
  Fig 2: Identifying Toothed Segment Position For Loosening Screws
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Loosen and unscrew ten M10 x 29 (internal serration) fastening screws. Carefully remove the flywheel (it is quite heavy - so be careful).
1. 2.1. Fastening screws must be replaced.
  
  Fig 3: Loosening Fastening Screws
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.