WM 136019 Removing And Installing Flywheel (Turbo Coupe, Turbo CABRIO, Gt3, Gt2): Removal

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Overview Of Flywheel

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

NOTE: Removing and installing flywheel

Leaks
Risk of damage to the flywheel and adjacent components

→ Be very careful during removal and installation.

→ Get another person to help because of the weight.

Remove flywheel.
1. 1.1. Loosen and unscrew the nine cheese head bolts (M10 x 62) while countering at the crankshaft pulley using special tool holding wrench 9548 . Carefully take off flywheel.
Check clutch plate for wear.
For specified dimensions see → 305601 CHECKING CLUTCH PLATE FOR WEAR

Information

Check the friction surface of the flywheel. The flywheel must be replaced if it is damaged or discolored.
Check pressure plate and flywheel for wear; e.g. scoring or blueing on contact surfaces. Replace components if necessary.