Subsequent Work
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removing and installing flywheel
- Leaks
- Risk of damage to the flywheel and adjacent components
→ Be very careful during removal and installation.
→ Get another person to help because of the weight.
- Fit flywheel.
→ 136019 REMOVING AND INSTALLING FLYWHEEL .
→ 136019 REMOVING AND INSTALLING SINGLE-MASS FLYWHEEL .
→ Tightening torque: 85 Nm (63 ftlb.)
→ Tightening torque: 90 Nm (67 ftlb.)
Information
Loosen and tighten screws on the component according to specifications.
- Centre the clutch plate on the flywheel with the centering mandrel 9102
and install the pressure plate.
→ 305019 REMOVING AND INSTALLING CLUTCH .
→ Tightening torque: 23 Nm (17 ftlb.)
→ Tightening torque: 23 Nm (17 ftlb.)
- Install transmission.