Subsequent Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fit strut for rear apron and tighten screws.
→ Tightening torque, item 1: 3 Nm (2 ft. lb.)

→ Tightening torque, item 2: 10 Nm (7.5 ft. lb.)

Fig 1: Identifying Rear Apron Support
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit rear wheel. Use a socket-wrench insert P 300 to avoid damaging the wheel rims → 440519 REMOVING AND INSTALLING WHEEL - section on "Installing".