Installing Rear Silencer

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Insert the silencer into the vehicle from the wheel side and move it into installation position.
1. 1.1. Insert threaded bolts at the retaining points and fit two M8 lock nuts -1- .
  
  Fig 1: Identifying Rear Silencer Mounting Nuts
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  
  Fig 2: Identifying Front Silencer Mounting Nuts
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  
  Information
  - Apply a light coating of high-temperature grease (e.g. Optimoly HT, Part No. 000.043.004.00) on the clamp or pipe adapter before installation.
Slide the clamping sleeve over the front silencer pipe and move it into installation position.

Fig 3: Identifying Clamp Sleeve Installation Position
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 2.1. Fit the two hexagon nuts -1- and tighten to the prescribed torque.
  
  Fig 4: Identifying Clamping Sleeve Nuts
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit two M8 lock nuts on the rear silencer holders and tighten to the prescribed tightening torque.
Fit tailpipe with a new ball clamp and adjust it.
→ 263519 REMOVING AND INSTALLING TAILPIPE COVER .