Technical Values
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Cover plate for exhaust manifold to cylinder head | External Torx screw, M6 x 12 | Tightening torque | 10 Nm (7.5 ft. lb.) | ||
| Oxygen sensor to catalytic converter | Grease thread with prescribed lubricant before refitting | Tightening torque | 50 Nm (37 ft. lb.) | +/-8 Nm (+/- 6 ft. lb.) | |
| Exhaust manifold to cylinder head | External Torx screw, M8 x 21; always replace seal | Tightening torque | 30 Nm (22 ft. lb.) | ||
| Three-hole flange on exhaust manifold | Always replace M8 lock nuts and seal | Tightening torque | 23 Nm (17 ft. lb.) | ||
| Clamping sleeve between front and rear silencers | M8 thread, replace sleeve if necessary | Tightening torque | 23 Nm (17 ft. lb.) | ||
| Holding clamp for front silencer | Cheese head bolt, M8 x 50 | Tightening torque | 15 Nm (11 ft. lb.) |