Technical values
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
| Location |
Description |
Type |
Basic value |
Tolerance 1 |
Tolerance 2 |
| Pressure line to clutch slave cylinder and intermediate piece |
M12 x 1 |
Tightening torque |
20 Nm (15 ftlb.) |
|
|
| Clutch slave cylinder to transmission |
M10 |
Tightening torque |
45 Nm (33 ftlb.) |
|
|
| Holder to clutch slave cylinder and transmission |
M8 |
Tightening torque |
23 Nm (17 ftlb.) |
|
|
| Hose to clutch slave cylinder |
M14 x 1 |
Tightening torque |
30 Nm (22 ftlb.) |
|
|
| Pressure accumulator to clutch slave cylinder |
M14 x 1.5 |
Tightening torque |
30 Nm (22 ftlb.) |
|
|
| Drive shaft to transmission - manual transmission |
M10 x 1 |
Tightening torque |
90 Nm (67 ftlb.) |
|
|
| Transverse strut to rear-axle side sections |
M10 |
Tightening torque |
65 Nm (48 ftlb.) |
|
|
| Location |
Description |
Type |
Basic value |
Tolerance 1 |
Tolerance 2 |
| Pressure line to clutch slave cylinder and intermediate piece |
M12 x 1 |
Tightening torque |
20 Nm (15 ftlb.) |
|
|
| Clutch slave cylinder to transmission |
M10 |
Tightening torque |
45 Nm (33 ftlb.) |
|
|
| Holder to clutch slave cylinder and transmission |
M8 |
Tightening torque |
23 Nm (17 ftlb.) |
|
|
| Hose to clutch slave cylinder |
M14 x 1 |
Tightening torque |
30 Nm (22 ftlb.) |
|
|
| Pressure accumulator to clutch slave cylinder |
M14 x 1.5 |
Tightening torque |
30 Nm (22 ftlb.) |
|
|
| Drive shaft to transmission - manual transmission |
M10 x 1 |
Tightening torque |
90 Nm (67 ftlb.) |
|
|
| Transverse strut to rear-axle side sections |
M10 |
Tightening torque |
65 Nm (48 ftlb.) |
|
|