Removing Frame For Roll-Over Protection System

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Frame For Roll-Over Protection System Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Press in locking tabs -arrows A- and pull plug connections -1- off wire harness for roll-over protection system -arrow B- .

Fig 2: Disconnecting Plug Connections
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew fastening screw -1- and fastening nuts -2- from Z support -3- .

Fig 3: Removing Frame For Roll-Over Protection System
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew fastening screws -4- and carefully remove frame for roll-over protection system -5- upwards out of the vehicle.