Safety Instructions For Work On The Roll-Over Protection System
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Incorrect handling of roll-over protection system
- Roll-over protection system is activated
→ Remove ignition key.
→ Wait 1 minute before starting work.
→ Keep space clear for the roll-over protection system to move.
→ Only remove roll-over bar module when the roll-over bar is extended.
It is not permissible to perform repairs on the roll-over bar modules.
The roll-over bar modules must be replaced in the event of visible damage or pressure marks.
After assembly work on the roll-over protection system - but at least every 2 years - the function of the roll-over protection system must be tested by triggering it via the diagnostic interface of the PIWIS tester 9718 .
Only perform the function test on the roll-over protection system with the hardtop and cap removed and the convertible top open.