Installing AWS Control Unit

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Position AWS control unit on the holder and screw it down using the three fastening screws -2- .

Fig 1: Installing AWS Control Unit Screw And Holder
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Position AWS holder on the seat bracket and screw it down using the three fastening screws -1- .

Fig 2: Installing AWS Holder To Seat Bracket Screw
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Push electric connector onto AWS control unit until it is felt to engage.
Insert seat central connector into AWS holder and clamp by turning to the right.