The Automatic Belt Device Has Two Locking Functions
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- The first locking function is triggered by pulling the seat belt out quickly (belt extension acceleration).
Test
- Pull the belt strap out of the automatic belt device with a strong jerk.
If no locking effect occurs, the entire seat belt and belt buckle must be replaced.
In the event of faults in the extension or retraction of the seat belt, check whether the locking lug of the automatic belt device is engaged correctly in the sheetmetal bracket on the body.
- The second locking function is triggered by a change in the sequence of vehicle movement (vehicle-dependent locking function).
Test
WARNING:
Road tests on public roads
- Danger to other people on the roads
→ Perform drive tests on a stretch of road with no traffic.
- Fasten the seat belt.
WARNING:
Road tests on public roads
- Danger to other people on the roads
→ Perform drive tests on a stretch of road with no traffic.
- Accelerate the vehicle to 20 km/h (12 mph) and then perform an emergency stop with the foot brake.
If the belt is not locked by the blocking mechanism during the braking phase, the entire seat belt and belt buckle must be replaced.