Installing Front Three-Point Belt

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Front Three-Point Belt Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

The seat-belt pretensioner may only be installed when the ground terminal of the vehicle battery is disconnected.
The vehicle battery may only be re-connected after the re-installation of the belt has been completed.

Install seat-belt pretensioner. Observe direction of travel.

Fig 2: Installing Seat-Belt Pretensioner
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Tighten fastening screw -arrow B- . → Tightening torque: 50 Nm (37 ftlb.)+/-10 %
Insert electric connector -2- into the seat-belt pretensioner -arrow A- .

Fig 3: Locking Connector For Seat-Belt Pretensioner
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Using a screwdriver, for example, push in the lock in -direction of arrow- until it engages.
By gently pulling on the belt -1- , check the winding action of the belt strap.
Position deflector -2- and seat belt on the inner side section and secure with the fastening screws -1- . → Tightening torque: 10 Nm (7.5 ftlb.)

Fig 4: Installing Deflector
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

Ensure that belt strap can run properly!
Secure seat belt and fitting.

Fig 5: Securing Seat Belt
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 7.1. Secure fastening screw -2- , washer -3- , seat belt with fitting -4- and spacer sleeve -5- on inner side member. → Tightening torque: 50 Nm (37 ftlb.)+/-10 %
2. 7.2. Press cap -1- onto the fastening screw -2- (-arrow- ).