LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (19 - Engine - Cooling -- CARRERA (997)) >> WM 197819 Removing And Installing Coolant Temperature Sensor (Turbo Coupe, Turbo S Coupe, Turbo CABRIO & Turbo S CABRIO) >> Removing Coolant Temperature Sensor

Removing Coolant Temperature Sensor

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove crankcase vent line at the oil-filter housing.
    1. 1.1. Unscrew external Torx screw (E10, M6 x 20) -1-  at the oil-filter housing.
    2. 1.2. Release crankcase vent line -2-  at the locking ring and pull it off the engine ventilation cover on the cylinder head.
    3. 1.3. Pull crankcase vent line -3-  out of the oil-filter housing and set it aside.

      Place cloths underneath.

    4. 1.4. Replace O-rings.
    Fig 1: Identifying Crankcase/Vent Line Connection
    G09827879Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Remove coolant temperature sensor.
    1. 2.1. Release and disconnect the cable plug -4-  .
    2. 2.2. Loosen and unscrew coolant temperature sensor -5-  using the crow-foot wrench Nr.189-1  .
    3. 2.3. Replace sealing ring.
    Fig 2: Identifying Coolant Temperature Sensor
    G09827880Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals