Installing Coolant Temperature Sensor

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Replace sealing rings on crankcase vent line.
Install coolant temperature sensor.
1. 2.1. Fit coolant temperature sensor -5- and tighten it using the crow-foot wrench Nr.189-1 .
  → Tightening torque: 30 Nm (22 ft. lb.) -3 Nm (-2 ft. lb.)
2. 2.2. Connect cable plug -4- .
Fig 1: Identifying Coolant Temperature Sensor
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Install crankcase vent line at the oil-filter housing.
1. 3.1. Grease and fit new O-rings with Kluber Syntheso Glep grease (Porsche Part No. 000.043.204.68).
2. 3.2. Connect crankcase vent line -2- . The plug-in connector must lock with an audible click.
3. 3.3. Guide crankcase vent line -3- into the oil-filter housing.
4. 3.4. Screw in and tighten external Torx screw (M6 x 20) -1- on the vent line at the oil-filter housing.
  → Tightening torque: 10 Nm (7.5 ft. lb.)
  
  Fig 2: Identifying Crankcase/Vent Line Connection
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.