Technical Values
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Unit carrier to crankcase | External Torx screws, M8 x 50 | Tightening torque | 33 Nm (24 ft. lb.) | ||
| Unit carrier to crankcase | External Torx screws, M8 x 70 | Tightening torque | 33 Nm (24 ft. lb.) | ||
| Bracket for coolant pump to crankcase | External Torx screw, M6 x 20 | Tightening torque | 13 Nm (9.5 ft. lb.) | ||
| Bracket for coolant pump to crankcase | External Torx screw, M8 x 25 | Tightening torque | 33 Nm (24 ft. lb.) | ||
| Bracket for coolant pump to crankcase | External Torx screw, M8 x 25 | Tightening torque | 33 Nm (24 ft. lb.) | ||
| Thermostat housing to crankcase | External Torx screw, M6 x 50 | Tightening torque | 13 Nm (9.5 ft. lb.) | ||
| Thermostat housing lid | External Torx screws, M6 x 50 | Tightening torque | 13 Nm (9.5 ft. lb.) | ||
| Thermostat housing lid | External Torx screws, M6 x 40 | Tightening torque | 13 Nm (9.5 ft. lb.) | ||
| Intake coolant pipe | External Torx screw, M6 x 12 | Tightening torque | 13 Nm (9.5 ft. lb.) | ||
| Water connection piece | External Torx screw, M6 x 25 | Tightening torque | 13 Nm (9.5 ft. lb.) | ||
| Vacuum line | External Torx screw, M6 x 12 | Tightening torque | 13 Nm (9.5 ft. lb.) | ||
| Threaded bolt on engine carrier bracket | Stud, M10 x 120 | Tightening torque | 5 Nm (3.5 ft. lb.) |