Component Overview

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Coolant Regulator Housing Components

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Torx screws, M6 x 50
Coolant regulator housing
Torx screw, M6 x 40
Seal for inside of coolant regulator
Seal for outside of coolant regulator
Coolant regulator
Seal for coolant regulator housing

Loosen spring band clamp -4- and pull off coolant hose -3- .

Fig 2: Identifying Coolant Breather Hose And Engine Supply Hose
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew M6 x 40 Torx screw -3- .
Unscrew three M6 x 50 Torx screws -1- .

Fig 3: Identifying Coolant Regulator Housing Screw
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Turn coolant regulator housing -1- to the right and remove coolant regulator -2- .

Fig 4: Turning Coolant Regulator Housing
Courtesy of PORSCHE CARS NORTH AMERICA, INC.