Installing Coolant Pump

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

Grease O-rings, hoses and lines in the cooling system with Kluberplus Gel (Part No. 000.043.205.93).

Grease the coolant pump seal with Kluberplus Gel.
Information

Specifications for wrench sizes (a/f specifications) for screw heads are described as follows:
- Torx screws: (E..) for external Torx, (T..) for internal Torx.
- Hexagon-head bolts (internal and external hexagon): Wrench size (a/f)
Fit the coolant pump.
1. 2.1. Fit the coolant pump initially using five external Torx screws (E10, M6 x 20) -1- .
2. 2.2. Fit and tighten one external Torx screw (E12, M8 x 25) -2- .
  → Tightening torque: 33 Nm (24 ft. lb.)
3. 2.3. Tighten five external Torx screws (E10, M6 x 20).
  → Tightening torque: 13 Nm (9.5 ft. lb.)
  
  Fig 1: Identifying Coolant Pump Screws
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.