Installing Coolant Pump

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

Grease O-rings, hoses and lines in the cooling system with Kluberplus Gel (Part No. 000.043.205.93).

Grease the coolant pump seal with Kluberplus Gel.
Fit coolant pump.
1. 2.1. Fit the pump using six external Torx screws.
2. 2.2. Fit and tighten screws uniformly.
  → Tightening torque: 13 Nm (9.5 ft. lb.)
  
  → Tightening torque: 23 Nm (17 ft. lb.)
  
  Fig 1: Overview For Coolant Pump Component
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  1. Coolant pump
  2. 5 x external Torx screw (E10), M6 x 20
  3. 1 x external Torx screw (E12, M8 x 25)