Installing Additional Coolant Pump

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

For all lubrication points, use Kluber Syntheso Glep (Part No. 000.043.204.68).

Install additional coolant pump. Grease hoses and connection pieces using the prescribed lubricant.
1. 1.1. Fit lower coolant hose.
  Fit coolant hose -5- to bottom of pump and tighten screw-type clamp.
2. 1.2. Fit and tighten screw -4- on additional coolant pump holder.
  → Tightening torque: 10 Nm (7.5 ft. lb.)
3. 1.3. Fit upper coolant hose.
  Fit coolant hose -3- to top of additional coolant pump and secure with the spring band clamp.
4. 1.4. Connect cable plug -2- .
  
  Fig 1: Identifying Additional Coolant Pump
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.