Removing Air Guide For Side Radiator

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

Specifications for wrench sizes (a/f specifications) for screw heads are described as follows:

Torx screws: (E..) for external Torx, (T..) for internal Torx.
Hexagon-head bolts (internal and external hexagon): Wrench size (a/f)

Remove air guide in driving direction, left.
1. 1.1. Unscrew two tapping screws (T 27) -1- .
2. 1.2. Pull air guide out of the plastic clips -2- .
  
  Fig 1: Identifying Side Radiator Air Guide
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove air guide at the right in direction of travel in the same way as the air guide at the left in direction of travel.
1. 2.1. Pull outside temperature sensor -arrow- out of the air guide from behind and leave it hanging at the connecting cable.
  
  Fig 2: Locating Outside Temperature Sensor
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.