Installing Electric Fan (With Frame)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Install electric fan in frame.
1. 1.1. Position electric fan in frame. Screw in and tighten three M6 hexagon nuts (a/f 10) -1- .
  → Tightening torque: 10 Nm (7.5 ft. lb.)
2. 1.2. Secure electric line to the frame with a tie-wrap.
  
  Fig 1: Identifying Electric Fan With Frame
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Slide electric fan with frame into the guides -2- .
1. 2.1. Bend electric fan with frame from the inside out.
2. 2.2. Screw in and tighten tapping screws (T 25) -1- .
  
  Fig 2: Identifying Cooling Fan
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Install bracket from below.
1. 3.1. Fit hose holder into the guide and screw in and tighten the screw (a/f 10, M6 x 16) -1- .
  → Tightening torque: 13 Nm (9.5 ft. lb.)
2. 3.2. Screw in and tighten nuts (a/f 13, M8 x 12) -2- .
  → Tightening torque: 23 Nm (17 ft. lb.)
3. 3.3. Fit and secure washers and sheetmetal clips -3- .
  
  Fig 3: Identifying Electric Fan Side Bracket
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Secure bracket -2- at the bottom.
1. 4.1. Screw in and tighten screw (a/f 13, M8 x 12) -1- .
  → Tightening torque: 23 Nm (17 ft. lb.)
  
  Fig 4: Identifying Cooling Fan Bottom Bracket
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Clip in vent line -1- at the holder for the bracket -2- in the wheel housing.

Fig 5: Identifying Vent Line
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Connect plug connection -1- for electric fan.

Fig 6: Identifying Fan Cable Connector
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit holding strut -1- and tighten M6 nuts (a/f 10) -2- .
→ Tightening torque: 13 Nm (9.5 ft. lb.)

Fig 7: Identifying Cooling Fan Side Bracket And Strut
Courtesy of PORSCHE CARS NORTH AMERICA, INC.