Removing Slide/Tilt Sunroof Trim

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Slide/Tilt Sunroof Trim Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Position the slide/tilt sunroof trim -dimension X- approx. 80 mm in front of the roof edge cut-out.

Fig 2: Positioning Slide/Tilt Sunroof Trim
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Disengage left and right inner side panels. Pull out the connector springs -A- on the gate and carefully pull the slide/tilt sunroof trim upwards.

Fig 3: Removing Slide/Tilt Sunroof Trim
Courtesy of PORSCHE CARS NORTH AMERICA, INC.