LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (70 - Linings, Insulation -- CARRERA (997)) >> WM 707549 Eliminating Noise Symptoms - Reworking Rear Side Trim Panel (Creaking Noise Between Side Trim Panel And Collar On Rear Seat Backrest Locking Element) (CARR. CABRIO, CARR. S CABRIO, CARR. 4 CABRIO, CARR. 4S CABRIO & Turbo CABRIO) >> General Information >> Causes And Remedial Action

Causes And Remedial Action

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Cause

The collar on the rear seat backrest locking pin is rubbing against the rear side trim panel (leather) and causes creaking noises.

Remedial action

In the event of a complaint, clean the surface of the collar where it comes into contact with the side trim panel and grease with Krytox.

scientia non olet · About LEMON Manuals