Installing Rear Cover

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

Observe assembly sequence!
The rear cover in the middle must be stuck on first, then the rear cover at the left and right.

Clean body flanges.
1. 1.1. Remove adhesive residue on the body flanges and clean the body flanges using cleaning agent.
Install rear cover in the middle.
1. 2.1. Pull off protective film on the bonding surface.
2. 2.2. Position centering notch -A1- of the rear cover in the middle -2- and centering notch -A2- of the rear center panel on top of each other -Arrow A- and press on rear cover in the middle -2- .
3. 2.3. Press rear cover in the middle -2- in under the C-pillar cover -3- (-Arrow B- ).
  
  Fig 1: Installing Rear Cover In Middle
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Install rear cover at the left and right.
1. 3.1. Pull off protective film on the bonding surface.
2. 3.2. Position rear cover at the left and right -1- at the rear cover in the middle -2- with the gap dimension -X- (-Arrow A- ). → Gap dimension X: 1 mm
3. 3.3. Press on rear cover at the left and right -1- and move it out until it is touching the roof pillar flange -Arrow B- .
  
  Fig 2: Installing Rear Cover At Left And Right
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.