Installing B-Pillar Trim Panel

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying B-Pillar Trim Panel Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Push grommet -5- onto lug of the B-pillar trim panel -4- and insert in bottom of the B-pillar.

Fig 2: Installing B-Pillar Trim Panel
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw down B-pillar trim panel -4- with fastening screw -3- .
Position sash-guide mount -2- on the B-pillar and tighten with fastening screw -1- . Tightening torque → Tightening torque: 37 ft. lb.
Press peg of the seat beat height adjuster actuator -1- into the bore of the fastening screw.

Fig 3: Installing Seat Belt Height Adjuster Actuator
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Check sheetmetal clips -2- , replacing if necessary.

Fig 4: Installing Coat Hook Bracket
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Carefully press coat hook bracket -1- into the sheetmetal clips -2- at the bottom of the B-pillar trim panel.