Installing Handle (Bucket Seat)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Handle Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Insert handle -1- into the cover -2- (-Arrow A- ) and press it into the retaining clip -3- on the cover -2- (-Arrow B- ).

Fig 2: Clipping In Cover On Handle
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

The guide pin on the handle must be inserted into the mounting point -Arrow- on the door trim panel.
Insert handle -1- into the door trim panel and secure with the fastening screws -2- .

Fig 3: Installing Handle
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw in fastening screws -3- on the back of the door trim panel. → Tightening torque: 7 Nm (5.0 ft. lb.)