Removing Rear Wall Trim Panel

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Pointed or sharp objects

Risk of cracks, pricks or cuts

→ Wear personal protective gear.

Fig 1: Identifying Rear Wall Trim Panel Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Unscrew fastening nuts -1- .

Fig 2: Loosening Control Unit Holder
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

Only for vehicles with subwoofer.
Remove subwoofer holder -2- at the left and right.
Lift control units holder -3- up slightly.
Lift rear wall trim panel -1- at the front -arrow A- and pull it sideways out of the side trim panel on the right -arrow B- .

Fig 3: Removing Rear Wall Trim Panel
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Carefully pull rear wall trim panel -1- forwards -arrow C- and take it out of the side trim panel on the left -arrow D- .

CAUTION: Pointed or sharp objects

Risk of cracks, pricks or cuts

→ Wear personal protective gear.

Fig 1: Identifying Rear Wall Trim Panel Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Unscrew fastening nuts -1- .

Fig 2: Loosening Control Unit Holder
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

Only for vehicles with subwoofer.
Remove subwoofer holder -2- at the left and right.
Lift control units holder -3- up slightly.
Lift rear wall trim panel -1- at the front -arrow A- and pull it sideways out of the side trim panel on the right -arrow B- .

Fig 3: Removing Rear Wall Trim Panel
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Carefully pull rear wall trim panel -1- forwards -arrow C- and take it out of the side trim panel on the left -arrow D- .