Intermediate Maintenance (A Markets)
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Applies only to A markets → 0X00IN OVERVIEW OF A, B AND C MARKETS .
- The engine oil and oil filter must be changed every 10, 000 km/6, 000 miles in vehicles that are operated in countries where leaded fuel is used.
- If the mileage for a regular service is not reached, intermediate maintenance must be carried out after 2, 6, 10...... years.
- The term 'checking' includes all necessary subsequent work such as adjusting, readjusting, correcting and topping up, but does not include repairing, replacing and reconditioning parts or assemblies.
- Maintenance item > Check drive belt < must always be performed 60, 000 km/40, 000 miles after replacing the drive belt. .
| Intermediate maintenance after: 30, 000, 90, 000, 150, 000, 210, 000 km etc./ 20, 000, 60, 000, 100, 000, 140, 000 miles etc. |
OK |
|---|---|
| Diagnostic system: read out fault memory; reset maintenance interval → WM 033500 ON-BOARD DIAGNOSIS (OBD) (911 CARR. COUPE, 911 CARR. S COUPE, 911 CARR. CABRIO, 911 CARR. S CABRIO, 911 CARR. 4 COUPE, 911 TURBO COUPE, 911 CARR. 4S COUPE, 911 TARGA 4, 911 TARGA 4S, 911 CARR. 4 CABRIO, 911 CARR. 4S CABRIO, 911 TURBO CABRIO, 911 GT3, 911 GT3 RS 911 GT2) | |
| Change engine oil and oil filter → WM 170155 CHANGING ENGINE OIL AND OIL FILTER (TURBO COUPE, TURBO S COUPE, TURBO CABRIO, TURBO S CABRIO) | |
| Vehicle underbody and engine compartment: visual inspection for leaks (oils and fluids) and chafing damage (lines and hoses) Underbody panels: visual inspection for completeness, secure installation and damage |
|
| Coolant hoses: check condition Radiators and air inlets: visual inspection for external contamination and blockage Coolant: check level and antifreeze → CHECKING COOLING SYSTEM |
|
| Particle filter: replace filter element → REMOVING AND INSTALLING PARTICLE FILTER | |
| Brake system: visual inspection of brake pads and brake discs for wear (without removing and installing wheels) → 463802 CHECKING THICKNESS OF REAR BRAKE PADS → CHECKING THICKNESS OF FRONT BRAKE PADS |