LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 107 (47 - Brakes - Hydraulic Brake System, Regulator -- CARRERA (997)) >> WM 474119 Removing And Installing Rear Brake CALLIPER (Turbo Coupe, Turbo S Coupe, Turbo CABRIO, Turbo S CABRIO, Gt3, Gt2, Gt3 RS, Gt2 RS) >> Removing rear brake calliper (standard brake system and PCCB)

Removing rear brake calliper (standard brake system and PCCB)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open combination plug connection and pull out connector for brake pad wear indicator. Unclip brake pad wear indicator wire from the holders.
  2. Loosen holder (M6 screw) -2-  and brake line -1-  at the brake calliper. Close off brake line and brake calliper using suitable plugs.

    Loosen fastening screws -3-  and remove brake calliper (with brake pads fitted).

    Fig 1: Identifying Brake Calliper/Brake Line
    G09826273Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
scientia non olet · About LEMON Manuals