LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (44 - Wheels, Tires, Suspension Alignment -- CARRERA (997)) >> WM 449503 Suspension Alignment, Complete (Gt3, Gt2, Gt3 RS, Gt2 RS, Gt3 RS 4.0) >> Preliminary Work

Preliminary Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prepare the measuring station (combined rotary/sliding plates and weighing plates) and set it up on the wheel base.
  2. Carry out measuring preparations (full tank, fill in washer fluid and set the prescribed tire pressure).
  3. Drive vehicle onto measuring station. Drive as carefully as possible to avoid bottoming the vehicle (the front spoiler).

    Due to the reduced vehicle height, additional -stepped drive-on ramps and intermediate layers, if necessary-must be used to drive onto the floor-mounted measuring platforms. Measuring platforms without an inclination are unsuitable.

    Fig 1: Identifying Stepped Drive-On Ramp
    G09825951Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals