Further to 3: Fitting The Wheel On The Vehicle

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

Never use an impact bolter.
Observe information on the two-piece wheel bolt. This is described in the section on wheel removal and installation (fitting wheel on vehicle) → 440519 REMOVING AND INSTALLING WHEEL .

Fit wheel using a suitable commercially available tool.
Screw in wheel bolts by hand and then tighten evenly. Start at the top when tightening. Always observe the specified tightening torque of 130 Nm (96 ftlb.).
Tyre pressure according to the specifications.